Soluble polyimide as liquid crystal perpendicular alignment layer

Journal of Materials Science - Three polyimides (PIs) were prepared from a diamine containing biphenyl ester group as a side chain and a corresponding dianhydride chosen from...     

A non-invasive learning branch to capture leaf-image attention for tree species classification

Multimedia Tools and Applications - Tree species classification is a necessary and challenging task for both multimedia technique and forestry engineering. Continuous developments in multimedia and...     

Dynamic voltage scaling based energy-minimized partial task offloading in fog networks

Wireless Networks - With the dynamic voltage scaling (DVS) technology, the terminal node (TN) can dynamically adjust its computational speed, thus providing a new way to save energy during task...     

Multi-UAV Collaborative Wireless Communication Networks for Single Cell Edge Users

Mobile Networks and Applications - Due to fast deployment, strong survivability and flexible scheduling, multiple unmanned aerial vehicles (UAV) can synergistically optimize the trajectory and...     

Improving gelling properties of myofibrillar proteins incorporating with cellulose micro/nanofibres

The effects of cellulose microfibres (CMFs, Average size: 100 ± 5 μm) and cellulose nanofibres (CNFs, Average size: 60 ± 3 nm) on the properties of myofibrillar protein (MP) gels from duck breast meat were studied. The results demonstrated that CMFs and CNFs were mostly connected to MP by non-covalent bonds, the diffusion and cross-linking of MP molecules was promoted, and a denser and more complete gel network was formed. With the increases of CMFs and CNFs concentration (0–10%), the hardness was increased by 13.15% and 19.78% for CMFs10% and CNFs10% gels, respectively, and the elasticity was increased by 40% and 80%, respectively. At the same concentration (0–10%), the increase in gel hardness, viscoelasticity and immobilised water content was greater in the CNFs-MP group than in the CMFs-MP group. The CNFs-MP group had a tighter gel network, and CNFs had a better potential to improve the gelation performance of MP.     

Graph-Theoretic Method on Topology Identification of Stochastic Multi-weighted Complex Networks with Time-Varying Delayed Coupling Based on Adaptive Synchronization

Neural Processing Letters - This paper is concerned with topology identification of stochastic multi-weighted complex networks based on adaptive synchronization. Different from previous work,...     

Effects of structural parameters on water film properties of transpiring wall reactor

Corrosion and salt deposition problems severely restrict the industrialization of supercritical water oxidation. Transpiring wall reactor can effectively weaken these two problems by a protective water film. In this work, methanol was selected as organic matter, and the influences of vital structural parameters on water film properties and organic matter removal were studied via numerical simulation. The results indicate that higher than 99% of methanol conversion could be obtained and hardly affected by transpiration water layer, transpiring wall porosity and inner diameter. Increasing layer and porosity reduced reactor center temperature, but inner diameter's influence was lower relatively. Water film temperature reduced but coverage rate raised as layer, porosity, and inner diameter increased. Notably, the whole reactor was in supercritical state and coverage rate was only approximately 85% in the case of one layer. Increasing reactor length affected slightly the volume of the upper supercritical zone but enlarged the subcritical zone.